Forum topic

4 posts / 0 new
Last post
kobi888
Infusion rate for FFP

 We are a cardiac unit but had a GI bleed pt.  She was elderly with poor veins but had a #22 angio lock in.  I understand FFP can be infused at a wide open rate, but we did not exceed 200cc/hr becuse we felt she had a potential for volume overload.  She was not in an emergent situation where time was a factor, but physician was upset we did not run the FFP faster.  We thought if we ran it faster we woud risk blowing one of the few veins she had left.  Is there any evidence based information on this?  Thanks 

lynncrni
 What was the total volume of

 What was the total volume of FFP to be infused? How long would this infusion require? How much bleeding was occuring? The FFP contains clotting factors and those may have been needed more rapidly than your scheduled infusion, depending on the volume. FFP is an isotonic solution, so no hypertonicity leading to fluid shifting, etc. Lynn

Lynn Hadaway, M.Ed., RN, NPD-BC, CRNI

Lynn Hadaway Associates, Inc.

PO Box 10

Milner, GA 30257

Website http://www.hadawayassociates.com

Office Phone 770-358-7861

kobi888
FFP

 Total volume was 4 units but pt was not bleeding much.  I was concerned about the FFP blowing the vein if it was infused any faster than 200cc in a pt with fragile veins anyway.  Any thoughts on this as it relates to vein size.  We were lucky to place a #22 gauze.  Thanks

lynncrni
 Infusion rate is not known

 Infusion rate is not known for "blowing" the vein. Many other factors are including site selection in an area of joint flexion or lack of appropriate catheter stabilization and joint stabilization if a joint must be used. Lynn

Lynn Hadaway, M.Ed., RN, NPD-BC, CRNI

Lynn Hadaway Associates, Inc.

PO Box 10

Milner, GA 30257

Website http://www.hadawayassociates.com

Office Phone 770-358-7861

Log in or register to post comments